stop citrix receiver login prompt for disconnected logon

The other options are specific to the Terminal Server on which they're set. If you modify the user's domain account, the user can't connect to the domain from ANY Terminal Server. Here you can uncheck the box, Allow Logon to Terminal Server. Stop connectivity for a specific user in User Manager by opening the user account and selecting CONFIG. Stop connectivity for a user or group to a specific socket connection in Terminal Server Connection Configuration under Security/Permissions. It's the same action as opening the connection and selecting Logon/Disabled under the Advanced Configuration. Stop connectivity to a specific socket connection in Terminal Server Connection Configuration under Connection/Disable.

Stop connectivity to the Terminal Server at the command prompt with the Command, 'Change Logon /Disable.' You can re-enable connectivity with 'Change Logon /Enable.' However, the Terminal Server service can't be paused, stopped, or disabled. For non-client connectivity, you can pause or stop the Net Logon or Server services in Control Panel/Services. Try setting this initially to 10 seconds and then increase by 10 seconds until 600 seconds. Disabling connectivity for Terminal Server Clients is different from disabling normal user connectivity. Both are in the registry key: HKEYLOCALMACHINESYSTEMCurrentControlSetControlCitrixwfshellTWI The first is LogoffCheckerStartupDelayInSeconds. If you need to disable connectivity to the Terminal Server, you have several options. For the time being - and as mere principle - I choose the hard way myself.įor further reference about launchctl, this AskDifferent answer is quite helpful.This article describes how to temporarily disable Terminal Server Client Logons.Īpplies to: Windows Server 2012 R2 Original KB number: 186627 Summary There is actually a discussion on their forum about this, but it appears dead and without response. But I've made it simple as an Automator task, which runs the mentioned commands to start the service and immediately after start the Citrix Receiver.Īctually, I have no doubt that it is relatively easy for Citrix to make this configurable as a preference.

Especially to repeat it every now and then. Unfortunately, this is a bit of a cumbersome process. Solution Set the registry key WSCReconnectMode to a number lower than 8. Launchctl load /Library/LaunchAgents/_Mac.plist To fix this, you manually need to start the services again: launchctl load /Library/LaunchAgents/ Unable to connect to the citrix AuthManager service The only issue now is that when you open the Citrix Receiver application, you may get something like the following error: In order to remove them completely from starting up automatically, I use the following commands: launchctl remove The process below allows you to stop autostart at boot.įirst, I fetched a list of all 'citrix' processes that run on startup: launchctl list | grep citrix Like mentions, starting and stopping is done through launchctl.

Stop citrix receiver login prompt for disconnected logon